800-245-8339
Pulling Eyes and Accessories
Tapered buttress threads thread into the innerduct for maximum pulling strength. These eyes connect directly to a Condux swivel. When properly sized and installed, these eyes will not pull out of innerduct until the pulling tensions have greatly exceeded the maximum pulling tensions recommended by the innerduct manufacturers.
NOTE: To determine correct pulling eye size, obtain the actual innerduct inside diamater (ID). The ID measurement must be greater than dimension A and smaller than dimension B (see diagram below).
| Part # |
Nominal Size (in) |
Innerduct ID Range (in) (A-B) |
Max OD (C) |
Hole Dia. (in) (D) |
Tang Thickness (E) |
Tang Hole Diameter (F) |
Tang Hole Location (G) |
| 08914110 | 3/4 | .71-.87 | 1.25 | .25 | .38 | .50 | .50 |
| 08914120 | 1 | .93-1.06 | 1.38 | .25 | .38 | .50 | .50 |
| 08914130 | 1-1/4 | 1.06-1.43 | 1.75 | .38 | .50 | .66 | .63 |
| 08914140 | 1-1/2 | 1.37-1.68 | 2.00 | .38 | .50 | .66 | .63 |
| 08914150 | 1-3/4 | 1.68-1.81 | 2.25 | .38 | .50 | .66 | .75 |
| 08914160 | 2 | 1.93-2.12 | 2.50 | .38 | .50 | .81 | .75 |